ECE R16 Manikin
Available Product Lines
- ATD Assembly
The ECE R16 manikin was developed as a loading device for testing vehicle safety belts in a simulated crash situation. The dummy represents a 50th percentile male adult in general size and weight distribution. For reasons of simplicity the dummy has no lower arms and only one lower leg and is made from a semi-translucent hard urethane proven to have good durability. The manikin is specified as a test device for ECE-regulation no. 16; "Uniform provisions concerning the approval of safety belts and restraint systems for adult occupants of power driven vehicles" and for EEC directive 82/319.
NOTE: Customers owning TNO-10s can replace the parts on their existing dummies with the R16 components.
The manikin consists mainly of 6 parts: head; neck; torso; two upper legs and one lower leg. The parts are connected by joints which allow movement in the mid-sagittal plane.
The head is a hollow polyurethane form reinforced by a polyester skull. The head can be rotated about an Atlas-axis joint.
The neck consists of 6 reinforced polyurethane discs around a steel roller chain. The stiffness of the neck is adjustable by means of a tensioning device.
The frame of the torso mainly consists of a steel skeleton covered by polyurethane. The skeleton consists of a steel hip tube, a roller chain representing the spinal column, a steel plate frame representing the ribs and a steel construction to represent the sternum. 6 Polyurethane tuning weights, each weighing 1 kilogram, are supplied with the dummy.
The upper legs consist of a polyurethane covered steel frame, provided with steel tubes at both ends to accommodate the hip joint on one side and the knee joint on the other. The hip joint is provided with space to fit 6 steel tuning weights.
The lower leg is a polyurethane covered steel tube with a steel footplate on one side and a steel tube on the other side.
The manikin is covered by a special overall accommodating the single leg. The overall is made of cotton and reinforced by a 200 mm wide strap around the lap area.
A soft foam cushion must be placed on the chest under the overall. The chest cushion compensates for the stiffness of the dummy's chest. The cushion is made of polyethylene foam.
Humanetics will continue to be the one-stop shop for test device solutions and grant customers a steady supply of quality ECE R16 manikins and spare components.
- Crash Test Dummies
- Frontal Impact
- Side Impact
- Rear Impact
- Aerospace & Military
- ATD Lead Disclosure
- Test Equipment
- Virtual Models